Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1999LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLESERVICE AND REPAIRCRUISE CONTROL CABLE REPLACEMENT
1999 Buick LeSabre V6-3.8L VIN K
Cruise Control Cable Replacement
1999 Buick LeSabre V6-3.8L VIN KSECTION Cruise Control Cable Replacement
REMOVAL PROCEDURE
IMPORTANT: Note the cable routing for replacement.
1. Remove the fuel injector sight shield.
2. Disconnect the cruise control cable from the following components:
^ The TBI cam (1)
^ The throttle body bracket (2)
3. Disconnect the cruise control cable from the cruise control module.
4. Disconnect the cable from the retainers (2).
INSTALLATION PROCEDURE
1. Connect the cruise control cable to the cruise control module.
2. Install the cruise control cable slug TBI cam (1). Ensure that the cable is under the hook.
3. Snap the cable to the throttle body bracket (2).
4. Connect the cable to the retainers (2).
5. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment. Cruise Control Cable Adjustment
6. Install the fuel injector sight shield.
IMPORTANT: Note the cable routing for replacement.
1. Remove the fuel injector sight shield.
2. Disconnect the cruise control cable from the following components:
^ The TBI cam (1)
^ The throttle body bracket (2)
3. Disconnect the cruise control cable from the cruise control module.
4. Disconnect the cable from the retainers (2).
INSTALLATION PROCEDURE
1. Connect the cruise control cable to the cruise control module.
2. Install the cruise control cable slug TBI cam (1). Ensure that the cable is under the hook.
3. Snap the cable to the throttle body bracket (2).
4. Connect the cable to the retainers (2).
5. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment. Cruise Control Cable Adjustment
6. Install the fuel injector sight shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.