Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1999LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSALARM MODULESERVICE AND REPAIR
1999 Buick LeSabre V6-3.8L VIN K
Alarm Module: Service and Repair
1999 Buick LeSabre V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE
1. Remove the IP storage compartment insert.
2. Remove the fastener from the rear edge of the module.
3. Remove the PASS-Key� II module from the bracket (1).
4. Disconnect the electrical connection(s).
INSTALLATION PROCEDURE
1. Connect the electrical connection(s).
2. Install the PASS-Key� II module to the bracket (1).
3. Install the fastener.
4. Install the IP storage compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.