Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1998LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIRHVAC PROGRAMMER
1998 Buick LeSabre V6-3.8L VIN K
HVAC Programmer
1998 Buick LeSabre V6-3.8L VIN KSECTION HVAC Programmer
Heater And A/C Programmer:
Remove or Disconnect
1. IP compartment, disengage stops and swing down.
2. Electrical and vacuum connectors.
3. Driver temperature valve link rod.
4. Screws and programmer from vehicle.
Install or Connect
1. Screws after positioning programmer.
Tighten
^ Screws to 1.4 N.m (12 lb. in.).
2. Electrical arid vacuum connectors.
3. Driver temperature valve link rod.
Adjust
^ Temperature valve link rod after installation.
4. IP compartment insert by pushing forward.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.