Fuse Block: Service and Repair

1998 Buick LeSabre V6-3.8L VIN KSECTION Service and Repair
Fuse Block Access Cover Replacement




Remove the fuse block cover (1) in order to access the fuses. Several fuses are also located in the relay center. Perform the following steps in order to remove the fuse block cover:

Removal Procedure
1. Depress the release tab.
2. Pull down on the cover (3).

Installation Procedure
1. Insert tabs on the fuse block cover (3) into the sound insulator.
2. Push upward to fasten the fuse block cover.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.