Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1998LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIRCRUISE RELEASE SWITCH REPLACEMENT
1998 Buick LeSabre V6-3.8L VIN K
Cruise Release Switch Replacement
1998 Buick LeSabre V6-3.8L VIN KSECTION Cruise Release Switch Replacement
REMOVAL PROCEDURE
NOTICE: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment could cause brake drag and excessive brake lining wear.
1. Remove the left sound insulator panel.
2. Disconnect the electrical connectors.
3. Remove the release switch assembly (1).
INSTALLATION PROCEDURE
1. Install the release switch assembly (1).
2. Connect the electrical connectors.
IMPORTANT: An incorrect adjustment may cause the cruise control system to work improperly.
3. Adjust the cruise control release switch. Refer to Cruise Release Switch Adjustment. Cruise Release Switch Adjustment
4. Install the left sound insulator panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.