Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1996CENTURY SEDAN L4-2.2L VIN 4REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONALIGNMENTSERVICE AND REPAIRFRONT WHEEL ALIGNMENTFRONT TOE ADJUSTMENT
1996 Buick Century Sedan L4-2.2L VIN 4
Front Toe Adjustment
1996 Buick Century Sedan L4-2.2L VIN 4SECTION Front Toe Adjustment
Toe-in is controlled by tie rod position. Adjustment is made by loosening the nuts at the steering knuckle end of the tie rods and rotating the rods to obtain proper toe-in setting. When adjusting toe-in, the tie rod boot clamps must be removed. After correct toe-in setting is obtained, torque tie rod nuts to 45 ft. lbs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.