Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1991CENTURY L4-151 2.5L VIN R TBIREPAIR AND DIAGNOSISSPECIFICATIONSELECTRICAL SPECIFICATIONSCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSOR
1991 Buick Century L4-151 2.5L VIN R TBI
Throttle Position Sensor
1991 Buick Century L4-151 2.5L VIN R TBISECTION Throttle Position Sensor
<0076>
| Voltage | 0.20 - 1.25 Note: TPS voltage is checked at idle. The maximum TPS reading at idle is 1.25 volts. |
| 0.33 - 1.33 Note: 1991 models only. TPS voltage is checked at idle. The maximum TPS reading, at idle, is 1.33 volts. The TPS has an auto zeroing feature. If the voltage reading is within the range of about 0.33 to 1.33 volts, the ECM will use that value as closed throttle. If the voltage reading is out of the auto zero range at closed throttle, check for a binding throttle cable or damaged linkage. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.