Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1987ELECTRA V6-231 3.8L VIN 3 FIREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRWINDOW REGULATOR MOTOR
1987 Buick Electra V6-231 3.8L VIN 3 FI
Window Regulator Motor
1987 Buick Electra V6-231 3.8L VIN 3 FISECTION Window Regulator Motor
WINDOW MOTOR
REMOVE OR DISCONNECT
1. Door trim panel
2. Water deflector
3. Window regulator and motor.
4. Motor from regulator using a 4.8 mm (3/16") drill bit, and drill out rivets holding motor to regulator.
INSTALL OR CONNECT
1. Motor to regulator using (3/16") rivets.
2. Window regulator and motor to door.
3. Water deflector.
4. Door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.