Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1987ELECTRA V6-231 3.8L VIN 3 FIREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCONTROL ASSEMBLY REPLACE
1987 Buick Electra V6-231 3.8L VIN 3 FI
Control Assembly Replace
1987 Buick Electra V6-231 3.8L VIN 3 FISECTION Control Assembly Replace
ELECTRA, LE SABRE
1. Disconnect battery ground cable.
2. Remove RH Trim Cover.
3. Remove Center Trim Cover.
4. Remove Radio.
5. Remove Control Assembly Rear-ward.
6. Remove Lamp Socket.
7. Remove Electrical & Vacuum Connectors.
8. Remove Temperature Cable.
9. Reverse to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.