Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011128I CONVERTIBLE (E88) L6-3.0L (N51)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDIAGRAMSDIAGRAM INFORMATION AND INSTRUCTIONSSIGNAL GLOSSARYSIGNAL NAMES WITH O
2011 BMW 128i Convertible (E88) L6-3.0L (N51)
Signal Names With O
2011 BMW 128i Convertible (E88) L6-3.0L (N51)SECTION Signal Names With O
Signal Names With O
OC_K-BUS Bus Signal, Seat Occupancy
OELST Signal, Oil Level Sensor
OKBF Lumbar Support Top Chamber, Passenger
OKFA Lumbar Support Top Chamber, Driver
O_SCA Signal, Soft Close
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.