SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011128I CONVERTIBLE (E88) L6-3.0L (N51)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTDESCRIPTION AND OPERATION14. MODIFICATIONS WITHIN PROGRAM
2011 BMW 128i Convertible (E88) L6-3.0L (N51)

14. Modifications within Program

2011 BMW 128i Convertible (E88) L6-3.0L (N51)SECTION 14. Modifications within Program




14. Modifications within program
Further modifications were carried out within the program which only slightly change the program sequence but which optimise the alignment in respect of comfort and speed. This is described below:
- Optimisation of the rim run-out compensation in respect of speed.
- Optimisation of the steering routines: Highlighted values within the gate can still be corrected. The message "Rotating plates not connected" no longer causes the steering routine to be cancelled. Further measurements can be carried out after the rotating plates have been connected.
- Standardisation of screen colours with the colours on the tablet.
- Addition of texts in several foreign languages.
- Elimination of program-related and cosmetic faults.
- Electronic water level.
- Omission of kingpin inclination measurement.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.