Removing and Installing/Replacing Control Unit for Adaptive Headlight

2006 BMW X3 (E83) (CANADA) L6-2.5L (M54)SECTION Removing and Installing/Replacing Control Unit for Adaptive Headlight



61 35 795 - Removing and installing (replacing) control unit for adaptive headlight





Important!
Read and comply with notes on protection against electrostatic discharge (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove right glovebox with housing 51 16 366 Removing and Installing Right Glovebox With Housing





Unlock catch (1) in direction of arrow.
Pull control unit for adaptive headlight (2) out of equipment carrier (3) slightly.
Unlock plug connection (4) and disconnect.
Remove control unit for adaptive headlight (2).





Replacement:
Carry out programming/coding Programming and Relearning.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.