Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025Q5 SPORTBACK PRESTIGEREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSCOMPONENT LOCATIONS: CONTROL MODULES IN FRONT PART OF VEHICLECOMPONENT LOCATIONS: CONTROL MODULES IN FRONT PART OF VEHICLEALL-WHEEL DRIVE CONTROL MODULE -J492- COMPONENT LOCATION AND CONNECTOR END VIEWPIN ARRANGEMENTS ALL-WHEEL DRIVE CONTROL MODULE -J492
2025 Audi Q5 Sportback Prestige
Pin Arrangements All-Wheel Drive Control Module -J492
2025 Audi Q5 Sportback PrestigeSECTION Pin Arrangements All-Wheel Drive Control Module -J492
| -T11b- (A) | Designation |
|---|---|
| 1 | Terminal 31 |
| 2 | All wheel drive clutch actuator 2 -V623-, near the rear axle |
| 3 | Terminal 30 |
| 4 | Drive shaft speed sensor -G970-, GND, near the rear axle |
| 5 | Drive shaft speed sensor -G970-, VCC, near the rear axle |
| 6 | Data-Bus Wire (FlexRay-Bus) |
| 7 | Data-Bus Wire (FlexRay-Bus) |
| 8 | Terminal 15 |
| 9 | Drive shaft speed sensor -G970-, Signal, near the rear axle |
| 10 | Data-Bus Wire (FlexRay-Bus) |
| 11 | Data-Bus Wire (FlexRay-Bus) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.