Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025Q5 SPORTBACK PRESTIGEREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWIRING97 WIRINGCONTROL MODULESCOMPONENT LOCATION OVERVIEW - CONTROL MODULES
2025 Audi Q5 Sportback Prestige
Component Location Overview - Control Modules
2025 Audi Q5 Sportback PrestigeSECTION Component Location Overview - Control Modules
- Nut
- Quantity: 2
- 2 Nm
- Body
- Data Bus on Board Diagnostic Interface -J533-
- There are different versions. Refer to the appropriate Electronic Parts Information (ETKA).
- Overview. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Nut
- Quantity: 2
- Tightening specification Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Left A-Pillar
- Mount
- For the Vehicle Electrical System Control Module -J519-
- Removing and Installing. Refer to Vehicle Electrical System Control Module -J519- MOUNT, REMOVING AND INSTALLING .
- Vehicle Electrical System Control Module -J519-
- Removing and installing: LHD refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING, LHD , RHD refer to appropriate service information
- Body
- Bracket
- For the Garage Door Opener Control Module -J530-
- Garage Door Opener Control Module -J530-
- Removing and Installing. Refer to GARAGE DOOR OPENER CONTROL MODULE, REMOVING AND INSTALLING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.