Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Windshield Projection Head Up Display Control Module J898, Removing And Installing: Removing
-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .
-- Remove the windshield projection head up display control module cover. Refer to INSTRUMENT PANEL/WINDSHIELD PROJECTION (HEAD-UP DISPLAY) COVER, REMOVING AND INSTALLING .
-- Move instrument panel noise insulation to the side.
-- Cover the windshield projection control module -1- with a soft cleaning cloth.
-- Remove the bolts -arrows-.
-- Remove the windshield projection control module -1- until the connectors are accessible.
-- Disconnect the connectors.
-- Remove the windshield projection control module -1-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.