Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025Q4 E-TRON PREMIUM PLUS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWARNING SYSTEMSDRIVER ASSISTANCE SYSTEMS98 ASSISTANCE SYSTEMSPERIPHERAL CAMERAPERIPHERAL CAMERA, CALIBRATINGNOTES
2025 Audi Q4 e-tron Premium Plus, AWD
Peripheral Camera, Calibrating: Notes
2025 Audi Q4 e-tron Premium Plus, AWDSECTION Notes
Special tools and workshop equipment required
- Calibration System :VAS 721 001
Calibration of the peripheral camera is necessary:
Condition
- The installation position of a camera in the vehicle changed.
- The Peripheral Camera Control Module -J928- was replaced.
- When adjusting the overlap range of the individual cameras.
Condition
The calibration requirements must be met.
- Refer to CALIBRATION CONDITIONS
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.