Driver Assistance Systems Front Camera, Calibrating, Static Calibration (Stationary Calibration): Notes

2025 Audi Q4 e-tron Premium Plus, AWDSECTION Notes

Special tools and workshop equipment required 

  • John Bean - Wheel Alignment Computer :VAS701001 
  • :VAS 6331/1 
  • :VAS 6430 
  • :VAS 701 001/1 

Condition

Calibrating the front camera is necessary:

Condition

  • The installation position of the Driver Assistance Systems Front Camera -R242- in the vehicle has changed.
  • Rear axle toe/camber was adjusted.

Condition

The calibration requirements must be met.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.