Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025Q3 PREMIUM PLUSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISGENERIC SCAN TOOL (GENERAL INFORMATION) (DSPA)
2025 Audi Q3 Premium Plus
Generic Scan Tool (General Information) (DSPA)
2025 Audi Q3 Premium PlusSECTION Generic Scan Tool (General Information) (DSPA)
- St Generic Scan Tool
- General Information
- Description And Operation
- Notes
- On Board Diagnostic Systems
- Evaporative Emission System
- Electronic Throttle Control (Etc) System
- Electronic Power Control (EPC) Warning Lamp
- Engine Control Module (ECM)
- Malfunction Indicator Lamp (Mil)
- Controller Area Network (Can)
- Fuel Supply
- Ignition And Timing
- Variable Valve Timing
- Exhaust-Gas RECIRCULATION (EGR) System
- Secondary Air Injection
- Exhaust Systems
- Diagnosis And Testing
- Notes
- Preliminary Check
- Readiness Code
- Diagnostic Modes 01 - 0A
- Notes
- Diagnostic Mode 01 - Read Current System Data
- Diagnostic Mode 02 - Read Operating Conditions
- Diagnostic Mode 03 - Read DTC Memory
- Diagnostic Mode 04 - Erase DTC Memory
- Diagnostic Mode 05 - Read Oxygen Sensor Monitoring Test Results
- Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions - 2025 My
- Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle
- Diagnostic Mode 08 - Request Control Of On-Board System, Test Or Component
- Diagnostic Mode 09 - Request Vehicle Information
- Diagnostic Mode 0A - Request Emission-Related Diagnostic Trouble Codes With Permanent Status
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.