Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Dimensions: Notes
The body dimensions are only for inspection. The Alignment Bracket Set is standard.
Bolts, plugs, trim panels and attachments must be removed before the measuring procedure.
Use the Telescoping Gauge - 41.5-92.5cm :VAS 5159 or the Telescoping Gauge - 92-260cm :VAS 5160 to determine the body dimensions.
Make sure that the test probes are always the same length to avoid inaccuracy when measuring.
Body Front
Dimensions are only for checking. The alignment bracket set is standard.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.