Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Data Bus On Board Diagnostic Interface, Information Electronics Control Module 1, Emergency Call Module Speaker
J533
Data Bus on Board Diagnostic Interface
J794
Information Electronics Control Module 1
R335
Emergency Call Module Speaker
T2g
2-Pin Connector, Black
T12b
12-Pin Connector, Blue
T16e
16-Pin Connector, Black
T16ex
16-Pin Connector, Black
T17c
17-Pin Connector, Red
T17cx
17-Pin Connector, Red
T54d
54-Pin Connector, Blue
TALU
Coupling Point on Left A-Pillar, Bottom
TCPM
Coupling Point on Instrument Panel, Center
*
For Vehicles Without Emergency Call Module
*2
For Vehicles with Emergency Call Module
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.