Electronic Steering Column Lock Control Module, Mobile Device Charger 1, Near Field Communication Control Module 2, Near Field Communication Antenna 2

2025 Audi A6 allroad Premium PlusSECTION Electronic Steering Column Lock Control Module, Mobile Device Charger 1, Near Field Communication Control Module 2, Near Field Communication Antenna 2
GWW4AH-044080421Courtesy of AUDI OF AMERICA, LLC

J519 

Vehicle Electrical System Control Module

J764 

Electronic Steering Column Lock Control Module

J1146 

Mobile Device Charger 1

J1170 

Near Field Communication Control Module 2

R351 

Near Field Communication Antenna 2

SG 

Fuse Panel G

SG9 

Fuse 9 on Fuse Panel G

T2ei 

2-Pin Connector, Black

T2eo 

2-Pin Connector, Black

T2ep 

2-Pin Connector, Black

T4o 

4-Pin Connector, Black

T5br 

5-Pin Connector, Black

T17c 

17-Pin Connector, Red

T17cx 

17-Pin Connector, Red

T54a 

54-Pin Connector, Black

TALU 

Coupling Point on Left A-Pillar, Bottom

213 

Ground Connection (in Instrument Panel Wiring Harness)

332 

Ground Connection 4 (in Instrument Panel Wiring Harness)

687 

Ground Connection 1 on Center Tunnel

A175 

Connection 58s (in Instrument Panel Wiring Harness)

B397 

Comfort System CAN Bus High Connection 1 (in Main Wiring Harness)

B406 

Comfort System CAN Bus Low Connection 1 (in Main Wiring Harness)

Depending on Equipment

*2 

For Vehicles with Telephone Charging Station

*3 

Country-Specific

*4 

Refer to Applicable Wiring Diagram for Fuse Positions

*5 

Omitted as a Running Change

*6 

Running Change

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.