Overview - Accelerator Pedal Module

2025 Audi A4 allroad Premium PlusSECTION Overview - Accelerator Pedal Module
Fig 1: Accelerator Pedal Module
GWWA20-11305Courtesy of AUDI OF AMERICA, LLC
  1. Accelerator Pedal Module -GX2-
    • with:
      • Accelerator Pedal Position Sensor -G79-
      • Accelerator Pedal Position Sensor 2 -G185-
      • Equipped on some models: Active Accelerator Pedal Motor -V592-
    • Check using the Vehicle Diagnostic Tester.
    • Removing and Installing. Refer to Accelerator Pedal Module -GX2-, REMOVING AND INSTALLING .
    • Depending on the engine/transmission combination, an adaptation must be performed after replacing.
    • If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.
  2. Pedal Bracket
  3. Connector
    • Make sure it is attached securely
  4. Bolt
    • 8 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.