Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Power Control (EPC) Warning Lamp
When the ignition is switched on, the engine control module (ECM) checks the electronic throttle control system for static system integrity (e.g. circuit integrity, communications, etc); the electronic power control (EPC) warning light is turned on via the Instrument Cluster during this process. Shortly after engine start, the EPC warning light is turned off if no malfunction in the electronic throttle control system is detected. In the event of a malfunction while the engine is running, the ECM will activate the EPC warning light via the Instrument Cluster and at the same time, a Diagnostic Trouble Code (DTC) is stored in the ECM memory.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.