Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025A4 QUATTRO PRESTIGEREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSCOMPONENT LOCATIONS: CONTROL MODULES IN MIDDLE PART OF VEHICLECOMPONENT LOCATIONS: CONTROL MODULES IN MIDDLE PART OF VEHICLEA/C CONTROL HEAD (A/C, CLIMATRONIC) -E87- COMPONENT LOCATION AND CONNECTOR END VIEWPIN ARRANGEMENTS A/C CONTROL HEAD (A/C, CLIMATRONIC) -E87- (9AK)
2025 Audi A4 Quattro Prestige
Pin Arrangements A/C Control Head (A/C, Climatronic) -E87- (9AK)
2025 Audi A4 Quattro PrestigeSECTION Pin Arrangements A/C Control Head (A/C, Climatronic) -E87- (9AK)
| -T20d- (B) | Designation | -T16k- (A) | Designation | |
|---|---|---|---|---|
| 1 | 1 | LIN-Bus, Temperature Regulator Flap Motor -V68- | ||
| 2 | Data Bus On Board Diagnostic Interface -J533- | 2 | Temperature Regulator Flap Motor -V68- Defroster Flap Motor -V107- Recirculation Flap Motor -V113- Air Distribution Flap Motor -V428- Fresh air door motor -V438- | |
| 3 | Data Bus On Board Diagnostic Interface -J533- | 3 | Temperature Regulator Flap Motor -V68- Defroster Flap Motor -V107- Recirculation Flap Motor -V113- Air Distribution Flap Motor -V428- Fresh air door motor -V438- | |
| 4 | LIN-Bus | 4 | Evaporator Vent Temperature Sensor -G263- | |
| 5 | 5 | Left Footwell Vent Temperature Sensor -G261- | ||
| 6 | Sunlight Photo Sensor -G107- | 6 | Right Footwell Vent Temperature Sensor -G262- | |
| 7 | Sunlight Photo Sensor -G107- | 7 | ||
| 8 | Sunlight Photo Sensor -G107- | 8 | ||
| 9 | Sunlight Photo Sensor -G107- | 9 | Left Footwell Vent Temperature Sensor -G261- Right Footwell Vent Temperature Sensor -G262- Evaporator Vent Temperature Sensor -G263- | |
| 10 | 10 | |||
| 11 | 11 | |||
| 12 | 12 | |||
| 13 | 13 | |||
| 14 | 14 | |||
| 15 | 15 | |||
| 16 | High Pressure Sensor -G65- Humidity Sensor in Fresh Air Intake Duct -G657- | 16 | ||
| 17 | ||||
| 18 | ||||
| 19 | Terminal 31 | |||
| 20 | Terminal 30 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.