Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2025A4 QUATTRO PRESTIGEREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOEM GENERAL INFORMATIONGENERAL, TECHNICAL DATA (GENERAL INFORMATION)00 GENERAL, TECHNICAL DATAPNEUMATIC EDGE MILLING UNIT VAS882 005, APPLICATIONNOTES
2025 Audi A4 Quattro Prestige
Pneumatic Edge Milling Unit Vas882 005, Application: Notes
2025 Audi A4 Quattro PrestigeSECTION Notes
NOTE:
Note the attached operating instructions.
Delivery
- Toolbox
- Edge Milling Unit with Machine Attachment
- Adjustment Gauge
- Pin Wrench
- Protective Cover
- Flat Head Milling Tool - 6mm VAS882 005/1
- Round Head Milling Tool - 6mm VAS882 005/2
- Flat Head Milling Tool - 6mm for Aluminum VAS882 005/3
- Spot Weld Breaker - Cutting Oil VAS882 001/5
- Drill Wax for Aluminum Milling Tool
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.