Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pneumatic Edge Milling Unit Vas882 005, Application: Notes
2025 Audi A4 Quattro PrestigeSECTION Notes
NOTE:
Note the attached operating instructions.
Delivery
- Toolbox
- Edge Milling Unit with Machine Attachment
- Adjustment Gauge
- Pin Wrench
- Protective Cover
- Flat Head Milling Tool - 6mm VAS882 005/1
- Round Head Milling Tool - 6mm VAS882 005/2
- Flat Head Milling Tool - 6mm for Aluminum VAS882 005/3
- Spot Weld Breaker - Cutting Oil VAS882 001/5
- Drill Wax for Aluminum Milling Tool
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.