Pin Arrangements Heater Control Module -J65- (9AC)

2025 Audi A4 Quattro PrestigeSECTION Pin Arrangements Heater Control Module -J65- (9AC)
-T20p- (B) Designation   -T16j- (A) Designation
1     1 LIN-Bus, Rear Temperature Regulator Flap Motor -V137-
2 Data Bus On Board Diagnostic Interface -J533-   2 Rear Temperature Regulator Flap Motor -V137- Left Temperature Flap Motor -V158- Left Side Vent Motor -V299- Defroster Flap Motor -V107- Right Side Vent Motor -V300- Right Temperature Flap Motor -V159- Rear air distribution door motor -V427- Fresh air door motor -V438- Recirculation Flap Motor -V113-
3 Data Bus On Board Diagnostic Interface -J533-   3 Rear Temperature Regulator Flap Motor -V137- Left Temperature Flap Motor -V158- Left Side Vent Motor -V299- Defroster Flap Motor -V107- Right Side Vent Motor -V300- Right Temperature Flap Motor -V159- Rear air distribution door motor -V427- Fresh air door motor -V438- Recirculation Flap Motor -V113-
4 LIN-Bus   4 Evaporator Vent Temperature Sensor -G263-
5     5 Left Footwell Vent Temperature Sensor -G261-
6 Sunlight Photo Sensor -G107-   6 Right Footwell Vent Temperature Sensor -G262-
7 Sunlight Photo Sensor -G107-   7  
8 Sunlight Photo Sensor -G107-   8  
9 Sunlight Photo Sensor -G107-   9 Left Footwell Vent Temperature Sensor -G261- Right Footwell Vent Temperature Sensor -G262- Evaporator Vent Temperature Sensor -G263-
10     10  
11     11  
12     12  
13     13  
14     14  
15     15  
16 Humidity Sensor in Fresh Air Intake Duct -G657-   16  
17        
18        
19 Terminal 31      
20 Terminal 30      
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.