Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Notes
Special tools and workshop equipment required
- Radio Removal Tool :T10057
- Fiber-Optic Repair Set - Connector Protective Caps :VAS 6223/9 .
The Information Electronics Control Module 1 -J794- is located behind the glove compartment.
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle diagnostic tester .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.