Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012S4 QUATTRO SEDAN (8K2) V6-3.0L SC (CCBA)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSPECIFICATIONSWHEEL ALIGNMENT INFORMATION
2012 Audi S4 Quattro Sedan (8K2) V6-3.0L SC (CCBA)
Wheel Alignment Information
2012 Audi S4 Quattro Sedan (8K2) V6-3.0L SC (CCBA)SECTION Wheel Alignment Information
Wheel Alignment Information
Wheel alignment must only performed using VW/Audi-approved wheel alignment equipment.
Each time wheels are aligned, both front and rear wheels must be aligned.
Otherwise, proper vehicle driveability cannot be ensured.
• Axle alignment should not be performed until the vehicle has been driven 1,000-2,000 km, since it takes this long for the suspension to settle.
• The individual specifications should be followed as exactly as possible when making adjustments.
After adjusting the chassis on vehicles with ESP or ABS, calibrate the steering angle sensor (G85) after the axle alignment. Refer to vehicle diagnosis, testing and information system VAS 5051 in "Guided Functions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.