Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012S4 QUATTRO SEDAN (8K2) V6-3.0L SC (CCBA)REPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING SWITCHSERVICE AND REPAIR
2012 Audi S4 Quattro Sedan (8K2) V6-3.0L SC (CCBA)
Memory Positioning Switch: Service and Repair
2012 Audi S4 Quattro Sedan (8K2) V6-3.0L SC (CCBA)SECTION Service and Repair
Driver Memory Seat Control Head
Removing
- Turn off the ignition and remove the ignition key.
- Remove the front door trim.
- Disconnect the electrical connector - 2 -.
- Carefully release the retaining hooks - A arrows - using a small screwdriver.
- Press the driver memory seat control head (E97) - item 1 - out of the switch mount - 3 -.
Installing
Install in reverse order of removal, observing the following:
- Press the driver memory seat control head into the switch mount until the retaining hooks engage.
- Install the front door trim.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.