Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGRELAYS AND MODULES - STEERINGSTEERING COLUMN CONTROL MODULESERVICE AND REPAIRSTEERING COLUMN SWITCH MODULETURN SIGNAL SWITCH, CRUISE CONTROL SWITCH
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Turn Signal Switch, Cruise Control Switch
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Turn Signal Switch, Cruise Control Switch
Turn Signal Switch, Cruise Control Switch
Removing
- Remove steering angle sensor (G85). Refer to => [ Steering Angle Sensor ] Steering Angle Sensor.
• The following work procedures are shown with the steering column switch module removed.
- Release retaining clips with 1.0 mm feeler gauge - item 1 - - arrows - and remove left lever switch.
Installing
Install in reverse order of removal, noting the following:
- Make sure all fasteners and electrical connectors are properly engaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.