Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMSTART / STOP SWITCHSERVICE AND REPAIR
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Start / Stop Switch: Service and Repair
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Service and Repair
Start/Stop Mode Button
Removing
- Switch off ignition and remove ignition key.
- Remove the emergency warning switch. Refer to => [ Emergency Flasher Switch, from 06.2008 ] Emergency Flasher Switch, From 06.2008.
- Remove the selector unit trim.
- Releases the retaining spring - arrows - and remove the switch mount - 1 -.
- Disconnect the electrical connector - 3 -.
- Press the start/stop mode button (E693) - 1 - out of the switch mount - 2 - - arrow -.
Installing
Install in reverse order of removal, observing the following:
- Press the button into the switch mount.
- Remove the selector unit trim.
- Install the emergency warning switch. Refer to => [ Emergency Flasher Switch, from 06.2008 ] Emergency Flasher Switch, From 06.2008.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.