Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COVER
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Timing Cover
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Timing Cover
Timing Chain Upper Cover - Tightening Sequence
Tighten the bolts 1 through 5 in the sequence shown:
Tighten the bolts to 9 Nm
Timing Chain Guard Lower Section - Tightening Sequence for 15 Bolts
Tighten the bolts 1 through 15 in 2 stages in the sequence shown:
1. Tighten the bolts to 8 Nm
2. Tighten the bolts an additional 45°
Timing Chain Guard Lower Section - Tightening Sequence for 8 Bolts
Tighten the bolts - 1 through 8 - in 2 stages in the sequence shown:
1. Tighten the bolts to 4 Nm
2. Tighten the bolts an additional 45°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.