Wiper Motor With Wiper Motor Control Module, Through 05.2008

Wiper Motor with Wiper Motor Control Module, through 05.2008

Special tools, testers and auxiliary items required

• Pry lever (80-200)

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

The Wiper Motor Control Module (J400) is integrated in the windshield wiper motor.

Removing


Danger of damaging the plenum chamber cover.

• Coat the transition between the windshield and cowl panel trim - 2 - with some soapy water and carefully pull the cowl panel trim vertically out of the retainer on the windshield beginning at the edge of the window.


Danger of damaging the paint.

• Protect the fender from scratches with adhesive tape.








- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Windshield Wiper Arms.

- Remove the spray nozzles - arrow -.

- Push the spray jet with the lines connected through the opening in the plenum chamber.

- Remove the rubber seal - 1 - in the plenum chamber - 2 -.






- Remove plenum chamber cover - 2 - by carefully removing cover from retainer on windshield.








- Disconnect electrical connector - 2 -.

- Remove bolts - 1 - and - 3 -.

- Lift the wiper arm frame with the linkage and wiper motor and remove it toward the left and out of the plenum chamber.

Installing

Install in reverse order of removal, noting the following:

- Install wiper motor with wiper frame in vehicle.

- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Windshield Wiper Arms, Adjusting.

Tightening Specifications