Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION COILSERVICE AND REPAIR
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Ignition Coil: Service and Repair
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Service and Repair
Ignition Coils with Power Output Stages
Special tools, testers and auxiliary items required
• Puller (T40039)
Removing
- Release the electrical connectors on all ignition coils and remove them from the ignition coils.
- Using the (T40039) , remove all the ignition coils from the spark plug shaft.
Installing
- Insert all ignition coils loosely into each spark plug shaft.
- Align the ignition coils to the connectors and then connect all of the connectors simultaneously onto the ignition coils.
- Press the ignition coils uniformly onto the spark plugs by hand (do not use any impact tools to do this).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.