Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSSERVICE AND REPAIRDATA BUS ON BOARD DIAGNOSTIC INTERFACE ASSEMBLY OVERVIEW
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Data Bus On Board Diagnostic Interface Assembly Overview
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Data Bus On Board Diagnostic Interface Assembly Overview
Data Bus On Board Diagnostic Interface Assembly Overview
• Control modules connected to the CAN BUS systems,
1 Radio
2 CAN-Bus Infotainment
3 CAN-Bus Instrument Cluster
4 Instrument Cluster Control Module (J285)
• Instrument Cluster
5 CAN-Bus Diagnosis
6 Diagnostic Connection
• 16-pin connector
7 CAN-Bus Comfort
8 Comfort System Central Control Module (J393)
9 CAN-Bus Drive
10 Engine Control Module
11 Data Bus On Board Diagnostic Interface (J533)
• Gateway
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.