Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSLOCATIONSMODEL YEAR 2007-UP
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Model Year 2007-Up
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Model Year 2007-Up
Control Modules in Interior of Vehicle
Data Bus On Board Diagnostic Interface -J533-
Component Location:
In left footwell -Arrow-
Note:
• The Component Location fromData Bus On Board Diagnostic Interface -J533- are equal for right and left-hand drive.
Pin Arrangements:
A - Data Bus On Board Diagnostic Interface -J533-
Connector:
B - 20-Pin Connector -T20d-
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.