Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISMAINTENANCETECHNICAL SERVICE BULLETINSCUSTOMER INTERESTINSTRUMENTS - CANNOT RESET SERVICE INTERVAL DISPLAY
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Instruments - Cannot Reset Service Interval Display
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Instruments - Cannot Reset Service Interval Display
90 - Service interval display cannot be reset
90 11 27
2026756/2
August 4, 2011
Supersedes Technical Service Bulletin Group 90 number 11 - 25 dated June 29, 2011 for reasons listed below.
Affected Vehicles
Condition
The service interval display cannot be reset.
Technical Background
If the service interval display is reset under the menu point Service Work in Guided Functions, or in Guided Fault Finding, the counter for the mileage and time related service may not be reset. Therefore, Service due or Service! is still shown.
Production Solution
Not applicable.
Service
1. In Self Diagnosis, enter address code 17 (Instrument Cluster), and change adaptation channels 53 and 55 to zero. Do not replace the instrument cluster for this concern.
2. Carry out all service work as before.
Warranty
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.
90 11 27
2026756/2
August 4, 2011
Supersedes Technical Service Bulletin Group 90 number 11 - 25 dated June 29, 2011 for reasons listed below.
Affected Vehicles
Condition
The service interval display cannot be reset.
Technical Background
If the service interval display is reset under the menu point Service Work in Guided Functions, or in Guided Fault Finding, the counter for the mileage and time related service may not be reset. Therefore, Service due or Service! is still shown.
Production Solution
Not applicable.
Service
1. In Self Diagnosis, enter address code 17 (Instrument Cluster), and change adaptation channels 53 and 55 to zero. Do not replace the instrument cluster for this concern.
2. Carry out all service work as before.
Warranty
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.