Headlamp Control Module: Service and Repair

2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Service and Repair





Headlamp Range Control Module

Component location is on the front of the central tube for the instrument panel inside the driver footwell

Removing

- If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Remove the driver storage compartment.

- Disconnect electrical connector - 2 -.






- Remove screws - 3 - and - 4 - and remove headlamp range control module (J431) - item 1 -.

Installing

Install in reverse order of removal, noting the following:

If headlamp range control module was replaced, it must be re-coded.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Install the driver storage compartment.

Tightening Specifications






RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.