Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISBODY AND FRAMESPECIFICATIONS
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Body and Frame: Specifications
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Specifications
Technical Data
Type Plate / Vehicle Identification Number (VIN)
The vehicle identification number - B - (chassis number) is stamped into the upper inner longitudinal member.
The type plate - A - is fastened behind the right strut tower on the plenum chamber.
Vehicle Data Label
The vehicle data label is located at the rear in the spare wheel well.
For additional information concerning bonded joints refer to
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.