Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CCTA)REPAIR AND DIAGNOSISBODY AND FRAMESERVICE PRECAUTIONSBATTERY, WELDING PROCEDURES
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)
Battery, Welding Procedures
2012 Audi A3 (8PA) L4-2.0L Turbo (CCTA)SECTION Battery, Welding Procedures
Battery, Welding Procedures
• Before disconnecting battery ensure that radio code is available. Ensure radio is in an operational condition by inputting radio code before releasing vehicle to customer.
Before welding, you must disconnect both battery terminals and cover both battery poles.
You must remove the vehicle battery before performing work near the battery that could produce sparks.
CAUTION!
Switch off ignition before connecting battery!=> Electrical
Equipment 27 Battery
On vehicles with electronic ignition lock, ignition must be switched off before removal
There should not be any people inside the vehicle when connecting the battery!
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.