Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A3 (8PA) L4-2.0L TURBO (CBFA)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSPOWER LOCKSPOWER DOOR LOCK CONTROL MODULESERVICE AND REPAIR
2012 Audi A3 (8PA) L4-2.0L Turbo (CBFA)
Power Door Lock Control Module: Service and Repair
2012 Audi A3 (8PA) L4-2.0L Turbo (CBFA)SECTION Service and Repair
Comfort System Central Control Module
Special tools, testers and auxiliary items required
• Pry Lever - Rmv Outside Mirror (80-200)
Removing
- Component location, in luggage compartment right rear below side trim.
- Right rear luggage compartment trim removed.
- Disconnect the connectors - 1 - and - 2 -.
- Remove nuts - arrow - and remove holding plate from control module.
- Tighten the nuts to 4.5 Nm.
- Lay open the wiring harness at holding plate using (80-200).
- Disconnect electrical harness connectors - 1 - to - 3 -.
- Press clip - arrow - to the side and pull control module out of holding plate.
- When installing, reinstall cable ties in the same place at which they were removed earlier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.