Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSBACK WINDOW GLASSSERVICE AND REPAIRREAR LID WINDOW ASSEMBLY OVERVIEW
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Rear Lid Window Assembly Overview
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Rear Lid Window Assembly Overview
Rear Lid Window Assembly Overview
1 Rear Window
2 Adhesive Sealing Material
• Note varying spacing dimensions to window edge.
• Dimension - a - = 11 mm.
• Dimension - b - = 12.5 mm.
• Dimension - c - = 15.5 mm.
3 Roof Spoiler
4 Adhesive Stop Profile
• Must be adhered before window adhesive, near rear window heater distributing wire.
• Place inner edge of adhesive stop profile to outer edge of distributing wire for rear window heater and press on.
• Window adhesive must not come into contact with rear window defroster distributing wire.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.