Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISWINDOWS AND GLASSSERVICE PRECAUTIONS
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Windows and Glass: Service Precautions
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Service Precautions
Minimum Curing Times
• For safety reasons, use only electrically non-conductive 2K adhesive when installing windshield and rear window using the materials listed below.
• The vehicle can only be used after the minimum curing time has elapsed.
Adhesive Sealant, Removing from Window
It is recommended to use adhesive remover D 002 000 10 as a cleaning solution. Follow the safety precautions when using it.
When cleaning from vehicle interior out, the window just installed must not be pressed outward.
Paint Surfaces
- First, clean paint surfaces with a dry cloth. Remove residual adhesive with adhesive remover D 002 000 10.
Plastic Trim
- Allow the adhesive sealant to harden (approximately 1 hour) and then peel it off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.