Electronic Steering Column Lock Control Module

Electronic Steering Column Lock Control Module

Removing


Note the following before removing the steering column:

Create a sketch showing the:

• Routing of the electrical wiring harnesses.

• Securing of the electrical wiring harnesses.

• Cable tie locations.

This especially applies to the wiring harness to the electronic steering column lock control module (J764).

Note the following before installing the steering column:

• Route the electrical wiring harnesses exactly the way they were before removal.

• Secure the electrical wiring harnesses exactly the way they were before removal.

• Install all the cable ties that were loosened or cut in the same locations when installing the steering column.

• Make sure the wiring harness to the electronic steering column lock control module is not pinched and does not come into contact with sharp edges when adjusting the steering column.

Only the following steering column components need to be removed to replace the electronic steering column lock control module:

• Driver side airbag, refer to Removal and Installation.

• Steering wheel, refer to => [ Steering Wheel with Airbag ] Steering Wheel With Airbag.

• Steering column trim.

• The required electrical wires and connectors.

- Remove the steering column. Refer to => [ Steering Column ] Steering Column.

- Remove the bolt - 1 - and the electronic steering column lock control module - 2 -.







• After removing the control module, make sure no dirt or foreign objects enter the steering column.

Installing

Install in reverse order of removal. Pay attention to the following:

Tightening specification, refer to => [ Steering Column Assembly Overview ] Steering Column Assembly Overview.

• If only the electronic steering column lock control module was replaced, used the previously used control module bolt.

• If the steering column was replaced, then remove the protective cover and use the screws in the new steering column for the electronic steering column lock control module.

- When installing the electronic steering column lock control module, insert the pins - arrow A - in the groove - arrow B - on the steering column.






- After reconnecting the connector, - 2 - make sure the wiring harness - 3 - is secured by the clip - 5 -.






If the steering column needs to be adjusted, be careful not to pinch the wiring harness - 3 - for the electronic steering column lock control module - 1 - and that it does not come in contact with any sharp edges.

- If the electronic steering column lock control module was replaced, the following work must performed using the vehicle diagnostic, test and measuring system (VAS 5051 B). Select the program in "Guided Functions" and follow the prompts on the screen.

- If the steering angle sensor (G85) warning lamp in the instrument cluster comes on after replacing, then correct the fault using "Guided Fault Finding" in (VAS 5051 B). If necessary, calibrate the system. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.