Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONFUSE BLOCKLOCATIONSRELAY / FUSE PANEL W/ VEHICLE ELECTRICAL SYSTEM CONTROL MODULE -J519
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Relay / Fuse Panel w/ Vehicle Electrical System Control Module -J519
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Relay / Fuse Panel w/ Vehicle Electrical System Control Module -J519
Fuses
Relay / fuse panel with Vehicle Electrical System Control Module -J519-
Component Location Relay / Fuse panel with Vehicle Electrical System Control Module -J519- for models with left-hand drive:
Below driver's instrument panel
1) Only models with left-hand drive, models with right-hand drive => [ ] 6-Pin Connector Station A-pillar, Front Pass Side
Note:
• Illustration shows models with left-hand drive.
• Illustration for models with right-hand drive .
A - ABS Control Module Fuse 1 -S123- (1), 40 A
Component Location Relay / Fuse panel with Vehicle Electrical System Control Module -J519- for models with right-hand drive:
Below driver's instrument panel
2) Only models with right-hand drive, with left-hand drive => [ 6-Pin connector station A-pillar, front passenger's side ] 6-Pin Connector Station A-pillar, Front Pass Side
Note:
• Illustration shows models with right-hand drive.
• Illustration for models with left-hand drive .
A - Fuse Terminal 30, Trailer Operation -S77- (2), 30 A
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.