Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRPROCEDURESBATTERY, CHARGINGRAPID CHARGING THE BATTERY, VEHICLES WITHOUT BATTERY MONITORING CONTROL MODULE OR ENERGY MANAGEMENT CONTROL MODULE
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Rapid Charging The Battery, Vehicles Without Battery Monitoring Control Module or Energy Management Control Module
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Rapid Charging The Battery, Vehicles Without Battery Monitoring Control Module or Energy Management Control Module
Rapid Charging The Battery, Vehicles Without Battery Monitoring Control Module (J367) Or Energy Management Control Module (J644)
Procedure
• The battery temperature must be at least +10 °C.
Risk of explosion due to open flame, fire and smoking.
• On non-maintenance-free batteries, the sealing plugs must be installed tightly.
• Provide sufficient ventilation.
• A highly flammable gas forms when batteries are charged. Never enter rooms where batteries are being charged carrying an open flame or while smoking.
• Follow the battery charger and battery manufacturer safety requirements.
Risk of explosion on discharged battery with visual indicator.
• If the visual indicator has no color or is light yellow, the battery may not be tested or charged. Jump starting must not be used! There is a risk of explosion during testing, charging or jump starting. The battery must be replaced.
Risk of damaging the battery and vehicle electronic components.
• Do not rapid charge AGM batteries.
• Do not rapid charge batteries in vehicles with a battery monitoring control module (J367) or energy management control module (J644).
• Do not rapid-charge exhaustively discharged batteries.
• Rapid-charging of batteries should only be performed in exceptional circumstances (for example, jump starting) since rapid charging may cause damage.
• Battery must not be connected to vehicle electrical system when performing rapid charging. Disconnect the positive and negative cables from the terminals.
• The maximum charging voltage is 14.8 volt.
• If the battery must be replaced, follow the disposal regulations, refer to=> [ Pollution risk. ] Lead-Acid Battery Warnings and Safety Precautions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.