Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER HEAD ASSEMBLYSYSTEM SPECIFICATIONS
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
System Specifications
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION System Specifications
Cylinder Head
Tighten in 3 Stages:
Tighten to 40 Nm
Tighten an additional 90°
Tighten an additional 90°
Camshaft Guide Frame Tightening Specifications and Sequence
The illustration shows the guide frame for the left cylinder head.
Replace the guide frame bolts.
Tighten the bolts in 3 steps in the following sequence: - 1 to 21 -:
Install bolts by hand as far as the stop.
The guide frame must be touching the entire contact surface of the cylinder head.
Tighten to 8 Nm.
Tighten an additional 90°
Maximum warp 0.05 mm
Exhaust Manifold Tightening Torque and Sequence Specifications
Camshaft Gear/Sprocket Torque Specifications
Intake Manifold Tightening Torque and Sequence Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.