Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - ASMTCONTROL MODULELOCATIONS
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Control Module: Locations
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Locations
Control modules in front part of vehicle
Transmission Control Module (TCM) -J217- / Direct Shift Gearbox (DSG) Mechatronic -J743-
Component Location:
In transmission housing.
A - Transmission Control Module (TCM) -J217- / Direct Shift Gearbox (DSG) Mechatronic -J743-
A1 - 16-Pin Connector -T16r-
A2 - 8-Pin Connector -T8al-
A3 - 14-Pin Connector -T14h-
A4 - 14-Pin Connector -T14i-
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.