Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDIAGNOSTIC MODES 01 - 09DIAGNOSTIC MODE 01 - READ CURRENT SYSTEM DATA
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Diagnostic Mode 01 - Read Current System Data
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Diagnostic Mode 01 - Read Current System Data
Diagnostic Mode 01 - Read Current System Data
Diagnostic Mode 01 makes it possible to access current emissions-related measured values and diagnostic data. The original measured values (no replacement values), input and output data and system status information are displayed using Diagnostic Mode 1.
Test requirement
• Coolant temperature at least 80° C.
Procedure
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Diagnostic Mode 1: Obtain data."
- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID $05 Coolant temperature".
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
- Switch the ignition off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.